RTI T1-B Provozní pokyny stáhnout pdf (Strana 15)

It’s Under Control

CHAPTER 3 | OPERATION

GETTING STARTED

NOTE: The following steps for initial installation including removing the battery

door should be performed by an authorized service center or trained installer

only.

The T1-B is shipped with the battery plugged in. The installer should turn on

the power switch.

The T1-B is turned-on by touching any keypad button. If the tilt sensor is

enabled, picking up the unit will also turn it on.

THE SOURCE BUTTONS

The eight source buttons at the top of the T1-B keypad have a special function,

so they behave differently from the other buttons. These buttons are used to

select the active source “page.” Whenever a source button is selected, all of the

other buttons on the keypad will switch to the programming associated with

that page. In order to indicate the active page, a red LED is always illuminated

more brightly behind one of the source buttons.

Despite their special function, the source buttons can be programmed to run

commands or macros in the same way that the other buttons can.

USING THE KEYCAP LABELS

The T1-B includes ve sets of 32 keycaps that include labelling for sources and

functions.

Prior to applying the keycap labels, remove the bezel from the T1-B.

The bezel is held on with magnets.

Bezel

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Žádné komentáře

RTI T1-B Provozní pokyny Strana 15