RTI XP-3 Uživatelský manuál stáhnout pdf (Strana 2)

 

 

DigiLinX

™

Application Note

Application Note: 030061

NetStreams , DigiLinX, ControLinX, MediaLinX, SpeakerLinX and SwitchLinX are Trademarks of NetStreams LLC.

main +1 512.977-9393 / fax +1 512.977.9398 3600 W. Parmer Lane, Ste. 100; Austin, TX 78727

To enable control of DigiLinX from the RTI XP-8, first load the SerialToCommand driver onto the

ControLinX. Open DigiLinX Dealer Setup project file and select your matched ControLinX. Click the

IR/RS-232 tab, then select the driver dropdown and select SerialToCommand.lua.

Send configurations to all devices, and DigiLinX will be ready to receive commands through the

ControLinX.

On the RTI side, the XP-8 must be trained to send commands that DigiLinX understands, and the remote

must contain a GUI that the user can use to control DigiLinX. To configure the RTI processor and

remote, open RTI Integration Designer.

DigiLinX uses commands called ASCII to communicate. ASCII commands are text-based and can be

written by hand, or copied and pasted from DigiLinX Dealer Setup (recommended method). For a full list

of DigiLinX ASCII commands, please refer to the manual “Programming for 3

Party Control.”

-Cont’d-

1 2 3 4 5 6 7 8

Žádné komentáře

RTI XP-3 Uživatelský manuál Strana 2